Siemens Simatic S7-300 - Steps from the Selection of Analog Modules to Commissioning

Analog modules
6.1 Steps from the selection of analog modules to commissioning
S7-300 Automation System Module data
6-2 Manual, 08/2006, A5E00105505-04
6.1 6.1 Steps from the selection of analog modules to commissioning
Introduction
The table below contains the steps required to successfully complete commissioning of
analog modules.
Although this sequence is suggested, you may nonetheless carry out specific steps, or install
or commission other modules, at your own time (for example, assigning parameters to the
module).
Steps from the selection of analog modules to commissioning
1. Selecting the module
2. For certain analog input modules: Set the measuring type and range using the measuring
range module
3. Installing the module in the SIMATIC S7 system
4. Assigning module parameters
5. Connect the measuring transducers or loads to the module
6. Commission the configuration
7. Analyze the configuration if commissioning failed
More information on installation and commissioning
See the "Installation" and "Commissioning" chapter in the Installation Manual for your
automation system:
● S7-300 Automation System, Installation or
● S7-400 Automation System, Installation or
● Distributed I/O Device ET 200M
You will find the documentation online at:
http://support.automation.siemens.com/WW/view/de/