Siemens Simatic S7-300

Parameter sets of signal modules
A.4 Parameters of analog input modules
S7-300 Automation System Module data
Manual, 08/2006, A5E00105505-04
A-7
Structure of data record 1
The figure below shows the structure of data record 1 for the parameters of analog input
modules.
You enable a parameter by setting a logic "1" at the corresponding bit of byte 0.
 


%\WH
%\WH
%\WH
%\WH
%\WH
%\WH
%\WH
%\WH
%\WH
%\WH
%\WH
%\WH
%\WH
%\WH
1RLVHVXSSUHVVLRQ
+DUGZDUHLQWHUUXSWZKHQOLPLWH[FHHGHG
0HDVXUHPHQWFKDQQHOJURXS
0HDVXUHPHQWFKDQQHOJURXS
0HDVXUHPHQWFKDQQHOJURXS
0HDVXUHPHQWFKDQQHOJURXS
6HH&RGHWDEOH
1RLVHVXSSUHVVLRQV
RIWKHDQDORJLQSXWPRGXOHV
6HH&RGHWDEOH
IRUWKHPHDVXULQJUDQJHVRIWKH
DQDORJLQSXWPRGXOHV
&KDQQHOJURXS
&KDQQHOJURXS
&KDQQHOJURXS
&KDQQHOJURXS
0HDVXULQJUDQJH
KLJKE\WH
ORZE\WH
KLJKE\WH
ORZE\WH
KLJKE\WH
ORZE\WH
KLJKE\WH
ORZE\WH
0HDVXULQJPHWKRG
'LDJQRVWLFVLQWHUUXSWHQDEOH
&\FOHHQGLQWHUUXSWHQDEOH
1RWH)RUWKHFKDQQHOJURXSVRQO\RQHOLPLW
YDOXHIRUWKHUHVSHFWLYHILUVWFKDQQHOLVVHW
8SSHUOLPLWYDOXHFKDQQHO
JURXSFKDQQHO
/RZHUOLPLWYDOXHFKDQQHO
JURXSFKDQQHO
8SSHUOLPLWYDOXHFKDQQHO
JURXSFKDQQHO
/RZHUOLPLWYDOXHFKDQQHO
JURXSFKDQQHO
Figure A-3 Data record 1 for the parameters of analog input modules
Note
The representation of limits matches the analog value representation (see chapter 4.)
Observe range limits when setting the limit values.