Siemens SIMOCODE pro PCS 7

Description of the blocks
4.3 MMOprtn block
SIMOCODE pro PCS 7 Library V9.0
136 Programming and Operating Manual, 06/2017, A5E40899442002A/RS-AA/001
Table 4- 45 DiagEvt3 – event diagnostics for SIMOCODE pro devices
Bit
Meaning
0
Password protection active
1 Factory settings
2
Parameterization active
3 DM-FL configuration mode
4
DM-FL actual configuration and desired configuration different
5
DM-FL waiting for start-up test
6
DM-F incorrect PROFIsafe address or incorrect PROFIsafe parameter
28
EM open circuit
29
EM short circuit
Table 4- 46 DiagEvt3 – event diagnostics for PROFINET devices
Bit
Meaning
7
NTP clock set
8
NTP clock synchronized
9
Initialization module read in
10
Initialization module programmed
11
Initialization module erased
12
Initialization module write-protected, parameter changes not allowed
13
Memory module write-protected
14
Initialization module write-protected
15
Initialization module identification data write-protected
16
TM2 warning level T>
17
TM2 trip level T>
18
TM2 sensor fault
19
TM2 out of range
20 AM2 warning level 0/4-20mA >
21
AM2 warning level 0/4-20mA <
22 AM2 trip level 0/4-20mA >
23
AM2 trip level 0/4-20mA <
24
Limit monitor 5
25
Limit monitor 6
26
AM2 open circuit