Siemens SIMOCODE pro PCS 7

Parameter
A.7 Block parameter MMRevDhl
SIMOCODE pro PCS 7 Library V9.0
Programming and Operating Manual, 06/2017, A5E40899442002A/RS-AA/001
273
A.7
Block parameter MMRevDhl
Input parameters
Table A- 22 Input parameter MMRevDhl
Parameter
Data format
Default setting
Meaning
FFwdAut STRUCT
• Value: BOOL
• ST: BYTE
–
• 1
• 16#FF
1 = Start: Fast Forward Command in Auto Mode
FwdAut STRUCT
• Value: BOOL
• ST: BYTE
–
• 1
• 16#FF
1 = Start: Forward Start Command in Auto Mode
StopAut STRUCT
• Value: BOOL
• ST: BYTE
–
• 1
• 16#FF
1 = Stop: Stop Command in Auto Mode
RevAut STRUCT
• Value: BOOL
• ST: BYTE
–
• 1
• 16#FF
1 = Start: Reverse Start Command in Auto Mode
FRevAut STRUCT
• Value: BOOL
• ST: BYTE
–
• 1
• 16#FF
1 = Start: Fast Reverse Command in Auto Mode
FFwdMan
BOOL
FALSE
1 = Start: Fast Forward Command in Manual Mode
FwdMan
BOOL
FALSE
1 = Start: Forward Start Command in Manual Mode
StopMan
BOOL
FALSE
1 = Stop: Stop Command in Manual Mode
RevMan
BOOL
FALSE
1 = Start: Reverse Start Command in Manual Mode
FRevMan
BOOL
FALSE
1 = Start: Fast Reverse Command in Manual Mode
ModLiOp STRUCT
• Value: BOOL
• ST: BYTE
–
• 0
• 16#80
Input to Auto/Manual Commands
0 = Manual
1 = Link/Auto
AutModOp
BOOL
FALSE
1 = Auto Mode: Auto Mode by Operator
ManModOp
BOOL
TRUE
1 = Manual Mode: Manual Mode by Operator
AutModLi STRUCT
• Value: BOOL
• ST: BYTE
–
• 0
• 16#80
1 = Auto Mode: Auto Mode by Linked or SFC
ManModLi STRUCT
• Value: BOOL
• ST: BYTE
–
• 0
• 16#80
1 = Manual Mode: Manual Mode by Linked or SFC