Description of the blocks
4.4 Block for MMMeas measured value function
SIMOCODE pro PCS 7 Library V9.0
164 Programming and Operating Manual, 06/2017, A5E40899442002A/RS-AA/001
The operator permissions for control commands are configured in the OS_Perm structured
parameters. These are transferred to WinCC via the
OS_PermOut and OS_PermLog parameters.
The operator parameters are controlled via the FBs in CFC.
The activated parameter allows the operator to enter the desired commands.
The operator permissions control operation only in the faceplate.
Table 4- 72 Operator permissions – MMMeas
1 1 1 1 = Operator is permitted to change to ON
mode
3 3 3 1 = Operator is permitted to change to "Out
21 21 21 1 = Operator is permitted to read data from
22 22 22 1 = Operator is permitted to write at output
23 23 23 1 = Operator is permitted to write at output
OS_PermOut contains the release information of all parameters.
OS_PermLog contains the release based on the current modes.
To Next Page
Loading...
Need help?
General
