Siemens SIMOCODE pro PCS 7 User Manual

Description of the blocks
4.5 Block for statistical function MMStat
SIMOCODE pro PCS 7 Library V9.0
178 Programming and Operating Manual, 06/2017, A5E40899442002A/RS-AA/001
4.5.8
Enabled operations
The operator permissions for control commands are configured in the OS_Perm structured
parameters. These are transferred to WinCC via the
OS_PermOut and OS_PermLog parameters.
The operator parameters are controlled via the FBs in CFC.
The activated parameter allows the operator to enter the desired commands.
The operator permissions control operation only in the faceplate.
Table 4- 80 Operator permissions – MMStat
OS_Perm
bit
OS_PermOut
bit
OS_PermLog
bit
Description
0
0
0
Reserved
1 1 1 1 = Operator is permitted to change to "ON"
mode
2
2
2
Reserved
3 3 3 1 = Operator is permitted to change to "Out of
service" (Oos) mode
4...20
4...20
4...20
Reserved
21 21 21 1 = Operator is permitted to read data from the
device
22…31
22…31
22…31
Reserved
OS_PermOut contains the permission information of all the parameters.
OS_PermLog contains the permission evaluated based on the current operating states.

Siemens SIMOCODE pro PCS 7 Specifications

General

Product designation	SIMOCODE pro PCS 7
Integration	PCS 7
Communication interface	PROFIBUS DP
Protection class	IP20
Supply voltage	24 V DC
Digital inputs	Via connected modules
Digital outputs	Via connected modules
Analog inputs	Via connected modules
Analog outputs	Via connected modules
Operating temperature	-20°C to +60°C
Ambient temperature	-20 to +60 °C
Storage temperature	-40°C to +70°C
Relative humidity	5 to 95% non-condensing
Mounting type	DIN rail mounting