Siemens SIMOCODE pro PCS 7

Maintenance Station
5.1 Maintenance Station
SIMOCODE pro PCS 7 Library V9.0
Programming and Operating Manual, 06/2017, A5E40899442002A/RS-AA/001
231
SIMOCODE pro PROFINET – Maintenance Station
Display Remark Message Caused by
Unknown/untested - PLC in Standby
Trip Device [Subnet No.]/[Device No.]:
Bad, maintenance alarm
Tripping *)
• General Fault
• Controller Fault
• Protection has tripped
• Level monitoring low/high
• Miscellaneous
• Protection extended
(TM2) has tripped
• Level monitoring
extended (AM2) low/high
• Miscellaneous extended
(AM2)
• Event – DM-FP F-Prm
error
Failure Device [Subnet No.]/[Device No.]:
Failure
Failure of PROFINET
connection or Rack Fault or
Module Fault
Warning Device [Subnet No.]/[Device No.]:
Uncertain, maintenance
demanded
Warnings *)
• Protection has tripped
• Level monitoring low/high
• Miscellaneous
• Protection extended
(TM2) has tripped
• Level monitoring
extended (AM2) low/high
• Miscellaneous extended
(AM2)
Signaling Device [Subnet No.]/[Device No.]:
Good, maintenance required
Status signaling *)
• Signaling by controller
• Protection has tripped
• Signaling caused by
parameterization