Siemens SIMOCODE pro PCS 7

Table of contents
SIMOCODE pro PCS 7 Library V9.0
8 Programming and Operating Manual, 06/2017, A5E40899442002A/RS-AA/001
4.6.11.2 MMLog - Logbook ................................................................................................................ 195
4.7 MMRevDhl motor block ........................................................................................................ 197
4.7.1 Application ............................................................................................................................ 197
4.7.1.1 Description of MMRevDhl .................................................................................................... 197
4.7.1.2 Operating modes ................................................................................................................. 198
4.7.1.3 Mode changeover error ........................................................................................................ 200
4.7.1.4 Forcing operating modes ..................................................................................................... 201
4.7.1.5 Control functions for directions ............................................................................................ 202
4.7.2 Parameterizable functions via the Feature connection MMRevDhl ..................................... 203
4.7.3 Output signal for ready to start ............................................................................................. 204
4.7.4 Resetting of the block .......................................................................................................... 204
4.7.5 Limit value monitoring with hysteresis ................................................................................. 205
4.7.6 Rapid stop ............................................................................................................................ 205
4.7.7 Specify warning times for controls ....................................................................................... 205
4.7.8 Issuing maintenance release ............................................................................................... 206
4.7.9 Suppressing messages using the MsgLock parameter ....................................................... 206
4.7.10 Simulation ............................................................................................................................ 206
4.7.11 Monitoring functions ............................................................................................................. 207
4.7.12 Motor Protection ................................................................................................................... 209
4.7.13 Interlocking ........................................................................................................................... 209
4.7.14 Disabling interlocks .............................................................................................................. 212
4.7.15 Group fault ........................................................................................................................... 212
4.7.16 User-defined auxiliary values and user-defined status ........................................................ 213
4.
7.17 Message characteristics ...................................................................................................... 213
4.7.18 Fault handling ....................................................................................................................... 216
4.7.19 Invalid input signals .............................................................................................................. 216
4.7.20 Enable for measurement and statistics ................................................................................ 216
4.7.21 Enabled operations .............................................................................................................. 216
4.7.22
Status information ................................................................................................................ 218
4.
7.23 Restart lock after changing direction of rotation or switching off the motor using idle
time ...................................................................................................................................... 221
4.7.24 Selecting a unit of measure ................................................................................................. 222
4.7.25 Faceplate views ................................................................................................................... 223
4.7.25.1 MMRevDhl - Standard ......................................................................................................... 223
4.7.25.2 MMRevDhl - Maintenance ................................................................................................... 225
4.7.25.3 MMRevDhl - Preview ........................................................................................................... 227
5 Maintenance Station .............................................................................................................................. 230
5.1 Maintenance Station ............................................................................................................ 230
A Parameter .............................................................................................................................................. 234
A.1 MMDiag block parameter ..................................................................................................... 234
A.2 Structure of UDTs for MMDiag ............................................................................................. 237
A.3 Block parameter MMOprtn ................................................................................................... 244
A.4 Block parameter MMMeas ................................................................................................... 252
A.5 Block parameter MMStat ..................................................................................................... 260
A.6 Block parameter MMLog ...................................................................................................... 267
A.7 Block parameter MMRevDhl ................................................................................................ 273