Siemens SINAMICS G120D - Page 379

Index
Converter with control units CU250D-2
Operating Instructions, 04/2014, FW V4.7, A5E34261542B AA
379
Scaling, 135
Ramp-function generator, 126, 131
Ramp-up, 342
Rampup time,
Ramp-up time
Scaling, 135
Ready, 114
Ready to switch on, 114
Reference cam, 170
Reference point, 170
Reference point approach, 169, 170
Reference point approach, 169, 170
Reference point approach, 169, 170
referencing
Flying,
Referencing, 147
Absolute encoder adjustment,
Set reference point,
Regenerative feedback, 227
Regenerative power, 224
Replacing
Control Unit, 296
Gearbox, 296
Hardware, 296
Motor, 296
Power Module, 296
Reset
Parameter, 62, 62, 63, 240
Resolution, 149
Reversing, 126
Reversing cam, 170
Roller conveyor, 151, 169
Rotary table, 149, 151, 196
Rounding, 132
Rounding OFF3, 132
S
S7 communication, 85
Safe Brake Relay, 246
Safety function, 112
Safety Integrated Function Manual, 359
Saw, 224
SD (memory card), 258
Formatting, 258
MMC, 258
Self-test, 246
Sensor
Electromechanical, 360
Sensorless Vector Control (SLVC), 158
Sequence control, 113
Serial number, 368
Series commissioning, 251, 257
Set reference point, 104
Set up, 102, 103, 147, 204
Setpoint processing, 112, 126
Setpoint source, 112
Selecting, 120, 341
Shock and vibration, 329
Short-circuit monitoring, 213
Signal interconnection, 349
SIZER, 372
Skip frequency band, 126
Software limit switch, 101, 104
Speed
Limiting, 126
Speed deviation, 234, 235
Speed monitoring, 234, 235
SSI encoder, 73
SSI encoder (tested), 47
Stacker crane, 151
Stall protection, 232
Standards, 332
2006/95/EC, 332
EN 60146-1-1, 335
EN 60204-1, 332
EN 61000-2-4, 335
EN 61000-4-11, 335
EN 61000-4-2, 335
EN 61000-4-3, 335
EN 61000-4-4, 335
EN 61000-4-5, 335
EN 61000-4-6, 335
EN 61800-3, 332
EN 61800-3:2004,
EN 61800-5-1, 332
IEC 61800-3,
ISO 9001, 332
SEMI F47-0706, 332
Standstill monitoring, 164
Star connection (Y), 340
STARTER, 68, 239, 344
STARTER commissioning tool, 239
STARTER PC tool, 239
Starting characteristics
Optimization, 138
State overview, 113
Status message, 112
Status word 1, 98
Status word 2,
99
Status word messages, 108
STO (Safe Torque Off), 237
Acceptance test, 367
Selecting, 237