Siemens SINUMERIK 802D Training Manual

Notes
SINUMERIK 802D sl Operating and Service Training Manual Page 9
C83
C83
Section 3
Tool types for milling/drilling
Tool Types for milling/drilling G19 plane
PRESS
PRES
S
PRESS
If you wish to drill in the peripheral surface of your turned component,
you would choose the second softkey as your t
ool type
chosen soft key
Note: this tool type is chosen as long as the configuration of the machine is
set with the
turret behind the spindle centre line.

Siemens SINUMERIK 802D Specifications

General

Brand	Siemens
Model	SINUMERIK 802D
Category	Control Unit
Language	English