EasyManuals Logo

Siemens SINUMERIK 840D sl Function Manual

Siemens SINUMERIK 840D sl
2184 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #155 background imageLoading...
Page #155 background image
Basic logic functions: Continuouspath Mode, Exact Stop, LookAhead (B1)
Function Manual, 11/2006, 6FC5397-0BP10-2BA0
3
Table of contents
1 Brief Description ........................................................................................................................................ 5
2 Detailed description ................................................................................................................................... 9
2.1 General ..........................................................................................................................................9
2.1.1 Parameterization of the RESET response.....................................................................................9
2.1.2 Block change and positioning axes ...............................................................................................9
2.1.3 Block change delay........................................................................................................................9
2.2 Exact stop ....................................................................................................................................10
2.3 Continuous-path mode.................................................................................................................15
2.3.1 General ........................................................................................................................................15
2.3.2 Velocity reduction according to overload factor...........................................................................17
2.3.3 Rounding according to path criterion ...........................................................................................19
2.3.4 Rounding with maximum possible dynamic response on each axis............................................27
2.3.5 Smoothing the path velocity.........................................................................................................29
2.3.6 Dynamic response adaptation .....................................................................................................33
2.3.7 Technology G group ....................................................................................................................41
2.4 LookAhead...................................................................................................................................44
2.5 NC block compressor COMPON, COMPCURV, -CAD ...............................................................50
2.6 Combine short spline blocks........................................................................................................53
3 Supplementary conditions ....................................................................................................................... 55
3.1 Rounding and repositioning (REPOS) .........................................................................................55
3.2 Smoothing the path velocity.........................................................................................................57
4 Examples................................................................................................................................................. 59
4.1 Example of jerk limitation on the path..........................................................................................59
5 Data lists.................................................................................................................................................. 61
5.1 Machine data................................................................................................................................61
5.1.1 General machine data..................................................................................................................61
5.1.2 Channelspecific machine data.....................................................................................................61
5.1.3 Axis/spindlespecific machine data ...............................................................................................62
5.2 Setting data..................................................................................................................................63
5.2.1 Channelspecific setting data........................................................................................................63
5.3 Signals .........................................................................................................................................63
5.3.1 Signals from channel ...................................................................................................................63
5.3.2 Signals to axis/spindle .................................................................................................................63
Index........................................................................................................................................................ 65

Table of Contents

Other manuals for Siemens SINUMERIK 840D sl

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Siemens SINUMERIK 840D sl and is the answer not in the manual?

Siemens SINUMERIK 840D sl Specifications

General IconGeneral
Control TypeCNC
Number of AxesUp to 31
Max Number of Channels10
InterfacesEthernet, PROFIBUS, PROFINET, USB
Interpolation5-axis interpolation
Operating Temperature0°C to 45°C
Relative HumidityUp to 95% (non-condensing)
DisplayTFT color display, various sizes
Programming LanguagesDIN/ISO
Safety FeaturesSafety Integrated
PLCIntegrated PLC S7-300
Drive InterfaceSINAMICS S120
Data StorageCF card, USB
Operating SystemWindows-based

Related product manuals