Siemens SINUMERIK 840D sl Function Manual

Detailed description
2.4 Program test
Basic logic functions: Mode group, channel, program operation, reset response (K1)
Function Manual, 11/2006, 6FC5397-0BP10-2BA0
35
Changing the dry run feedrate
The effect of setting data:
SD42100 $SC_DRY_RUN_FEED
can be controlled using setting data:
SD42101 $SC_DRY_RUN_FEED_MODE.
The following options are available for changing the dry run feedrate:
1. Dry run feedrate is the maximum of the programmed feedrate and setting data SD42101.
2. Dry run feedrate is the minimum of the programmed feedrate and setting data SD42101.
3. Dry run feedrate is setting SD42101, regardless of the programmed feedrate.
A dry run feedrate can be selected in the automatic modes and activated on interruption of
an automatic mode or end of a block.
For more information on feedrate control, refer to:
References:
/FB1/ Function Manual, Basic Functions; Feeds (V1)
Display
Active dry run feedrate mode is indicated by a reversal in the relevant field in the status line
on the operator interface.
2.4.4 Skip part-program blocks
Identification
The operating function must be selected, the function must be activated, and the blocks in
question must be identified with a slash character.

Siemens SINUMERIK 840D sl Specifications

General

Control Type	CNC
Number of Axes	Up to 31
Max Number of Channels	10
Interfaces	Ethernet, PROFIBUS, PROFINET, USB
Interpolation	5-axis interpolation
Operating Temperature	0°C to 45°C
Relative Humidity	Up to 95% (non-condensing)
Display	TFT color display, various sizes
Programming Languages	DIN/ISO
Safety Features	Safety Integrated
PLC	Integrated PLC S7-300
Drive Interface	SINAMICS S120
Data Storage	CF card, USB
Operating System	Windows-based