EasyManuals Logo

Siemens SINUMERIK 840D sl Function Manual

Siemens SINUMERIK 840D sl
2184 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #968 background imageLoading...
Page #968 background image
Brief description
Basic logic functions: Transverse axes (P1)
6 Function Manual, 11/2006, 6FC5397-0BP10-2BA0
Programming the transversing paths
The traverse paths of a transverse axis programmed in the part program may be either
radius- or diameter-based. It is possible to switch between the two reference types with the
part program commands DIAMON (DIAMeter ON = diameter) and DIAMOF (DIAMeter OF =
radius). In this way, dimensional information can be taken directly from the technical drawing
without conversion.
Active parts program
When the part program DIAMON (dimensional information as diameter) is active, the
following is true for the transverse axis:
The setpoint and actual values that refer to the workpiece coordinate system are
displayed as diameter values.
System variables for setpoints and actual values that refer to the workpiece coordinate
system contain diameter values.
Offsets are entered, programmed and displayed in radius format.
Programmed end positions are converted to radius values internally.
The absolute interpolation parameters (e.g. I, J, K) for circular interpolation (G2 and G3)
are converted to radius values internally.
Measurement results that were determined by touch trigger probe in the workpiece
coordinate system are stored as diameter measurements.
Setpoints and actual values can be read in diameter format in the WCS with the aid of
system variables.
When the part program command DIAMOF (dimensional information as radius) is active, the
above-mentioned data is always entered, programmed, internally stored, read or displayed
as radius data.

Table of Contents

Other manuals for Siemens SINUMERIK 840D sl

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Siemens SINUMERIK 840D sl and is the answer not in the manual?

Siemens SINUMERIK 840D sl Specifications

General IconGeneral
Control TypeCNC
Number of AxesUp to 31
Max Number of Channels10
InterfacesEthernet, PROFIBUS, PROFINET, USB
Interpolation5-axis interpolation
Operating Temperature0°C to 45°C
Relative HumidityUp to 95% (non-condensing)
DisplayTFT color display, various sizes
Programming LanguagesDIN/ISO
Safety FeaturesSafety Integrated
PLCIntegrated PLC S7-300
Drive InterfaceSINAMICS S120
Data StorageCF card, USB
Operating SystemWindows-based

Related product manuals