11.03 6 Alarms
6.2 Alarms from SIMODRIVE 611 digital
© Siemens AG 2003 All Rights Reserved
SINUMERIK 840D/SIMODRIVE 611 digital SINUMERIK Safety Integrated (FBSI) - Edition 11.03
6-353
Response Mode group not ready
Channel not ready
NC start inhibit in this channel
NC stop for alarm
Alarm display
Interface signals are set
Remedy Please inform the authorized personnel/service department. Check the entry in
machine data MD 1331: $MD_SAFE_VELO_LIMIT[n] (limit values for safely-
reduced speed) correct, if necessary, and carry-out a power on.
Program continuation Power-down the control and power-up again.
301706 Axis %1 drive %2 parameterization of cam position invalid
Parameter %1 = NC axis number
%2 = drive number
Explanation At least one of the parameterized cams enabled via MD 1301:
$MD_SAFE_FUNCTION_ENABLE (enable safety-relevant functions) has failed
to comply with the rule that cam positions may not be located within the
tolerance range around the modulo position.
The valid tolerance range is:
•
for inactive cam synchronization (MD 1301 bit 7 = 0):
lower modulo value + POS_TOL ≤ cam position
upper modulo value - POS_TOL > cam position
• for active cam synchronization (MD 1301 bit 7 = 1):
lower modulo value + POS_TOL ≤ cam position
upper modulo value - POS_TOL - CAM_TOL > cam position
Explanations:
POS_TOL: Actual value tolerance (MD 1342: $MD_SAFE_POS_TOL
(tolerance, crosswise actual value comparison))
CAM_TOL: Cam tolerance (MD 1340: $MD_SAFE_CAM_TOL
(tolerance for safe cams))
lower/upper modulo values:
is defined using MD 1305: $MD_SAFE_MODULO_RANGE
(for rotary axes, the actual value range)
Response Mode group not ready
Channel not ready
NC start inhibit in this channel
NC stop for alarm
Alarm display
Interface signals are set
Remedy Please inform the authorized personnel/service department.
Check/correct parameter settings of cam positions in
MD 1336: $MD_SAFE_CAM_POS_PLUS (plus cam position for safe cams) or
MD 1337: $MD_SAFE_CAM_POS_MINUS (minus cam position for safe cams)
and carry-out power on.
MD 1305: Check $MD_SAFE_MODULO_RANGE (for rotary axes, the actual
value range for SN).
Program continuation Power-down the control and power-up again.
301707 Axis %1, drive %2 Invalid modulo value parameters for SN
Parameter %1 = NC axis number
%2 = drive number
Explanation The cam modulo range parameterized in $MD_SAFE_MODULO_RANGE (for
rotary axes, the actual value range for SN ) for a rotary axis has failed to
To Next Page
Loading...
Need help?
General
