5 Commissioning 11.03
5.5 Diagnostics
© Siemens AG 2003 All Rights Reserved
5-298 SINUMERIK 840D/SIMODRIVE 611 digital SINUMERIK Safety Integrated (FBSI) - Edition 11.03
Fig. 5-6 Status display SPL
In the "Variable" selection box, you can select:
$A_INSE(P) corresponds to simultaneous selection of
$A_INSE upper line, origin of the NCK and
$A_INSEP lower line, origin of the PLC
and effectively the same for the other variables:
$A_OUTSE(P)
$A_INSI(P)
$A_OUTSI
$A_MARKERSI(P)
The variables that have been selected and the associated bit areas are saved
and are taken into account when subsequently selecting the screen.
Using the select key, the following formats can be selected in the variable rows
B Binary
H Hexadecimal
D Decimal
The selected format applies for all of the variables displayed in the screens.
5.5.2 Diagnostics support by configuring your own extended alarm
text
In order to upgrade the level of diagnostics information when an error occurs,
certain Safety Integrated system alarms can be supplemented by a freely-
definable user text. For instance, for hardware-related faults, supplementary
information such as input designation, circuit diagram identification number or
similar can be included in the system alarm that is output.
SPL
To Next Page
Loading...
Need help?
General
