6 Alarms 11.03
6.3 Alarm suppression
© Siemens AG 2003 All Rights Reserved
6-356 SINUMERIK 840D/SIMODRIVE 611 digital SINUMERIK Safety Integrated (FBSI) - Edition 11.03
27104 - no
27105 - no
27106 - no
27107 - no
27124 - no
27200 - no
27201 - no
27202 - no
27203 - no
27204 - no
27205 - no
27206 - no
27207 - no
27220 - no
27221 - no
27222 - no
27223 - no
27224 - no
27225 - no
27240 - no
27241 - no
27242 - no
27250 - no
27251 - no
27252 - no
27253 - no
27254 - no
27255 - no
27256 - no
27299 - no
- 300500 no
- 300745 no
- 300746 no
- 300747 no
- 300748 no
- 300749 no
- 300776 no
- 301706 no
- 301707 no
- 301708 no
Reasons for not suppressing alarms:
• 27001-300911: The information content of the NCK alarm is more
extensive than that of the drive alarm and must continue to appear in the
alarm log so that this information is accessible to service personnel.
• 27002-300951: These alarms continue to be displayed separately because
under normal conditions they are never triggered by both channels
simultaneously and because simultaneous occurrence of these alarms
causes problems in the test stop interface.
• 27031-301701: Parameterization alarm - is no longer triggered on the
NCK side.
• 27032-300744: Checksum errors in the parameterization of the safety
MD are initiated once at power on and then usually do not re-occur. If
these alarms do occur, this indicates a problem in the MD parameterization
which can be separately changed for both monitoring channels.
• 27003: OEM monitoring functions are only implemented in the NCK.
To Next Page
Loading...
Need help?
General
