Commissioning
271
7SS52 V4 Manual
C53000-G1176-C182-3
7.3.3.2 Bay Unit
With the bay units, the display of their input/output states or the activation/deactivation
of relays can be done via DIGSI or via the integrated operation.
In the operator tree of the bay units, under the tests, the operator addresses for the
test sequence are stated, in the block as of 4700 for the binary inputs and as of 4800
for the relay control.
 For the binary inputs, the physical states are stated:
0: not activated, 1: activated.
 There are two operator addresses per relay for controlling the relays
one for the activation, e.g. 4801, and one for the deactivation, e.g. 4802.
Entering the password F3F1F3F1F3F1 is required for this function.
Operator address The binary input states (physical states) are displayed by selecting the corresponding
operator address and its confirmation.
 The states of the other binary inputs are stated in the operator tree under the ad-
dresses 4703 up to 4710 (7SS525) and 4720 (7SS523) respectively.
4700 STATE OF
BINARY INPUTS
Input sequence for determining the state of binary input 1
4701 BI1-STATE
- SHOW?
Physical state:
0: not activated
1: activated
E key or
J/Y key ->
4701 BI1-STATE
0
Input sequence for determining the state of binary input 2
4702 BI2-STATE
- SHOW?
E key or
J/Y key ->
4702 BI2-STATE
0
Physical state:
0: not activated
1: activated
www . ElectricalPartManuals . com
To Next Page
Loading...
Need help?
General
