Siemens SIRIUS 3RW52 - Page 108

Functions
7.8 Standard 3RW5 HMI
SIRIUS 3RW52 Soft Starter
108 Manual, 01/2019, A5E35630451002A/RS-AD/004
Display
Explanation
CNTRL (CONTROL)
LOCL
CNTRL
Manual mode Manual mode means that the 3RW5 HMI Standard is the
master control.
REMT
CNTRL
Automatic mode Automatic mode means that the 3RW5 HMI Standard is not
the master control. To make the unit the master control,
press the LOCAL / REMOTE key.
Measured values
Display
Explanation
...A
I AVG
The average of the 3 phase currents is displayed in amps.
...A
I L1
Current measured value phase L1 is displayed in amps.
...A
I L2
Current measured value phase L2 is displayed in amps.
...A
I L3
Current measured value phase L3 is displayed in amps.
Parameter display
Display
Explanation
..
xIe
Current limiting value as a multiple of the set rated operational current I
e
of the
motor.
...%
U ON
Starting voltage
...s
t ON
Ramp-up time
...s
t OFF
Ramp-down time
...
CLASS
Trip class for motor overload protection
...A
Ie
Rated operational current I
e
of the motor
....
RMode
AUTO
Auto RESET
MAN
Manual RESET
REMT
Remote RESET
...
PBADR
Station address for PROFIBUS (only displayed if a "PROFIBUS" communication
module is being used)
...
MODBS
Station address for Modbus (only displayed if a "Modbus RTU" communication
module is being used)