Mounting and dismantling
3.4 Installing / mounting / removing 3RW5 HMI
SIRIUS 3RW52 Soft Starter
Manual, 01/2019, A5E35630451002A/RS-AD/004
43
Note
Locking switch
Make sure that the locking switch on the rear of the 3RW5 HMI Standard is in the required
position.
For more information, see Chapter
Standard 3RW5 HMI (Page 105).
● Observe the coding of the plug and socket ① + ③.
● Lock the connector in the socket
②.
● Observe the cable routing:
① Cable routing to the bottom
③ Cable routing to the left
● Replace the hinged cover of the 3RW52 soft starter as required. (Page 58)
3.4.2 Removing Standard 3RW5 HMI
Procedure
● Pull the 3RW5 HMI Standard far enough out of the 3RW52 soft starter ① to gain access
to the HMI connecting cable.
● Unfasten the retaining elements of the HMI connecting cable
② and pull the HMI
connecting cable out of the 3RW52 soft starter
③.
To Next Page
Loading...
