Siemens SITRANS F - The I;O Data Control Menu

2-52
1010PFM-3GSection 2
In No Line Wrap mode:
Use or to scroll one column to the left or right.
Press + simultaneously or press + simultaneously to scroll eight
columns to the left or the right.
To get out of the display, press .
NOTE: In single channel FUS1010 units the Datalogger uses a compression scheme that pre-
cludes backward scrolling.
Important point about Datalogger resources and dual-channel systems
When logging data on both measurement channels simultaneously, please be aware that the Datalog-
ger stores reports in a single common file. It is important that you select Site ID to appear on each line
of data so that you can always identify which channel generated the report.
2.10 THE I/O DATA CONTROL MENU
This menu becomes available after picking a Meter Type and Channel. Use to assign functions for the
meter’s analog outputs and optional inputs. The Analog Out Setup assigns functions to the meter’s
current, voltage and pulse rate outputs. Each menu cell presents an option list of the available data
items. In addition, you can set up the alarm relays, enable and span the analog input ports.
ALT
ALT
MENU
Siemens Dual Path SITE1
Assign Data to Analog Outputs
I/O Data Control
Analog Out Setup
Relay Setup
Analog Input Setup
Use this menu to enable
and span optional
analog inputs.
Use this menu to
assign data functions
to analog outputs.
Use this menu t
o
assign alarm
functions to rela
y
outputs.