Siemens SITRANS F - Diagnostic Data Menu Structure

2-57
1010PFM-3G
Section 2
data item upon request. Note also that these menus contain in formation that may only be meaningful
to our technical support staff.
The available diagnostic data depends on the meter type and channel configuration. All diagnostic
items are available when you select channel 1 or 2 in [Dual Channel Flow], [Ch 1+2 Flow] or [Ch 1-2
Flow] modes. In [Dual Beam Flow] mode, all diagnostic items are available for [Path 1] or [Path 2].
Some items are not available (N/A) when you select the virtual channel [3]. In addition, selecting virtual
Channel 3, in either the [1+2 Flow] or [1-2 Flow] modes will limit the list to flow data only.
Diagnostic Data Flow Data Flow
Velocity F/S
Total
Vs m/s
Signal mV
Valc %
Vaer %
Alarm Status
Ancal
HiFlow
LoFlow
Application Info TN uSec
TL uSec
DeltaT nSec
Burst/Sec
% Accepted
Last Makeup
Makeup Status
Liquid Data Reynolds #
Temp 1
Temp 2
Site Setup Data fx (drive)
N (burst length
Ltn in
Vfmax
Vs max m/s
Vs min m/s
Empty %
Samples/Cycles
HF
Test Facilities Makeup
Graph
Tx Up
Tx Dn
Fixed ALC
Tx Up Fixed ALC
Tx Dn Fixed ALC
Graph AutoZero
Print Site Setup No/Yes
Date Site Created xx.xx.xx xx.xx.xx
Ú
Ú
Ú
Ú
Ú
Ú
Ö
Ö
Ö
Ö
DIAGNOSTIC DATA MENU STRUCTURE
Ö
Ö
Ö
Ö
Ö
Ö
Ö
Ö
Ú
Ú
Ú
Ú
Ú