6-11
1010PFM-3G
Section 6
992DFT Series CPVC or Kynar PDFA Flow Tube
Model
Identification
Flow
Direction
Indicator
Calibration factor (valid
for indicated flow
direction only)
Inlet
(FPT)
Outlet
(FPT)
Mounting
Bracket
Flow Direction
Indicator
Mounting
Bracket
OUTLET
(Use Swagelok®
Tube Fitting)
INLET
(Use Swagelok®
Tube Fitting)
1011FT Series 316 Stainless Steel Flow Tube
ADDITIONAL INSTALLATION NOTES
z All Flow Tubes are supplied with integral line connections. The end-user must supply any adapt-
ers, etc. required for line connection.
z When connecting a screwed fitting to a Kynar, Teflon (PFA) or CPVC Flow Tube, please start the
thread carefully to avoid cross threading. Hand-tighten only. If necessary, use Teflon tape manufac-
tured for plastic piping to effect a leak-proof seal (see Appendix A- Engineering Drawings for de-
tails).
z Whenever possible, use the mounting brackets to support the weight of the flow tube.
z Consult the supplied engineering drawing for important dimensional data.
To Next Page
Loading...
