4-13
1010PFM-3GSection 4
To set the Clock:
To enable numeric entry press .
Use the numeric keys to type the time (HH.MM).
To store the time press . This moves the cursor to RS-232 Setup.
4.7 RS-232 SETUP
Use RS-232 Setup menu to set operating parameters of the serial I/O port. Settings include baud rate,
parity, data bits, line feed, network ID number and waiting period before a RTS time-out. Only activate
RS-232 output if you intend to transmit serial data; to avoid burdening system with unnecessary data
transferals while it is performing flow computations.
NOTE: The RS-232 stop bit implementation is fixed. If you are using a communication program,
such as Windows 3.xx Terminal or Windows 95/98/NT/2000//XP HyperTerminal, that in-
cludes a field for stop bits; select 1 stop bit.
4.7.1 BAUD RATE
The Baud Rate menu sets the asynchronous serial transmission data transfer rate of the RS-232 port
providing a selection of baud rates up to 38,400 baud. The baud rate must match the baud rate setting
of receiving external device. The factory-set baud rate is 9600.
To change the Baud Rate:
To access the [Baud Rate] option list press
Move the cursor to the required baud rate press
To store selection press . This moves the cursor to [Parity].
ENT
RS-232 Setup Baud Rate 300
1200
2400
4800
9600
38400
Parity None
Odd
Space
Even
Mark
Data Bits 7
8
Line Feed No
Yes
Network ID xx (numeric entry)
RTS Key Time 0.0 Sec.
0.2 Sec.
0.4 Sec.
0.6 Sec.
0.8 Sec.
1.0 Sec.
2.0 Sec.
3.0 Sec.
4.0 Sec.
RS-232 SETUP MENU STRUCTURE
ENT
To Next Page
Loading...
