Siemens SITRANS LUT400 Series - Page 535

Page 222 SITRANS LUT400 (HART) – OPERATING INSTRUCTIONS A5E33329501
mmmmm
Parameters
Enable Pump 1 (2.9.3.1.) 173
Enable Pump 2 (2.9.3.3.) 173
Ending Day (2.14.3.6.) 190
Ending Month (2.14.3.7.) 190
Ending Ordinal (2.14.3.5.) 190
Energy Savings (2.7.2.2.) 155
External Sampler (2.11.4.) 179
External Totalizer (2.11.3.) 177
Fail-Safe (2.4.) 143
Fail-safe Fault Alarm (2.8.8.) 166
Fail-Safe mA Value (2.4.3.) 144
Far Range (2.2.5.) 141
Figure of Merit (3.2.9.1.) 204
Fill Rate per Minute (2.3.1.) 142
Firmware Revision (3.1.11.) 201
Fixed Temperature (2.12.1.4.) 181
Flow (2.15.) 190
Flow Exponent (2.15.3.2.) 192
Flow Log (2.10.4.) 174
Flow Log Mode (2.10.4.1.) 174
Flow Measurement (2.12.5.6.) 187
Flowrate Decimal (2.15.3.6.) 194
Flowrate Units (2.15.3.7.) 194
Frequency (2.1.7.) 140
Hardware Revision (3.1.10.) 201
Head Measurement (2.12.5.5.) 187
High Calibration Point (2.2.2.) 141
High Flowrate Alarm (2.8.9.) 168
High Flowrate Value OFF (2.8.9.3.) 168
High Flowrate Value ON (2.8.9.2.) 168
High Level Alarm (2.8.1.) 162
High Level Value (2.8.4.2.) 164
High Level Value (2.8.5.2.) 165
High Level Value OFF (2.8.1.3.) 162
High Level Value ON (2.8.1.2.) 162
High Temperature Alarm (2.8.7.) 166
High Temperature Value OFF (2.8.7.3.) 167
High Temperature Value ON (2.8.7.2.) 167
Highest Value (3.2.8.1.) 203
Hover Level (2.12.3.3.) 185
Identification (3.1.) 200
In-bounds Level Alarm (2.8.4.) 164
Inflow/Discharge Adjust (2.7.3.4.) 161
Installation Date (3.1.5.) 200
Interval (2.11.1.2.): Elapsed Time Relay (2.11.1.) 175
Interval (2.11.4.3.): External Sampler (2.11.4.) 179
K Factor (2.15.4.1.) 197
Language (6.) 219
LCD Contrast (2.13.2.) 188
Level (3.4.1.) 215
Level Measurement (2.12.5.1.) 187
Level Override Value (2.9.1.2.) 171
Level Setpoint Variation (2.7.2.1.2.) 154
Level Simulation Enable (3.4.1.1.) 215
Level To Spill (2.8.12.1.) 170
Level Value (3.4.1.2.) 216
Loader Revision (3.1.12.) 201
Parameter Name (Parameter Number) Page Number