Siemens SITRANS P - Level Units [16]; Volume Units [16]; Volume Flow Units [16]

See also
Application [05] (Page 110)
9.2.14.1
Level units [16]
Selects the unit for the "Level" measurement.
This parameter is only visible when you have selected the "Level" characteristic curve using the
"Application" parameter.
Setting range: m
cm
mm
in
ft
Factory setting: m
9.2.14.2 Volume units [16]
Selects the unit for the "Volume" measurement.
This
parameter
is only visible when you have selected a volume characteristic curve using the
"Application" parameter.
Certain units are displayed differently on the display and over remote operation. (Page 107)
Setting range: Display (header line) Display (enumeration) Remote operation
Gal Ga gal
Gal [UK] IGa gal (UK)
l l l
hl hl hl
m3 m3 m
3
in3 in3 in
3
Ft3 Ft3 ft
3
bu bu bu
Yd3 Yd3 yd
3
bbl bbl bbl
bbl [US] Ubb bbl (US)
Nl Nl Nl
Nm3 Nm3 Nm
3
SCF SCF SCF
Factory setting: m
3
9.2.14.3 Volume flow units [16]
Selects the unit for the "Volume flow" measurement.
Parameter assignment
9.2 Parameter assignment over device with display
SITRANS P320/P420 with 4 to 20 mA/HART
128 Operating Instructions, 11/2019, A5E44852162-AC