9.3.2 Quick start
You use the "Quick start" wizard to configure your device in five steps for the required
application:
● Step 1: Identification
●
Step 2: Application
● Step 3: Scaling
Note that you set the displayed pressure unit with the "Pressure units" (Page 107)
parameter and not with the wizard.
Set the unit of the selected application (e.g. volume, mass flow) also via the parameter
group "Settings > Current output > Scaling > Unit".
● Step 4: Fault current
● Step 5: Summary
The summary provides an overview of the "old" and "new" parameters.
To store the parameters in SIMATIC PDM and transfer them to the device, click the "Apply"
button.
9.3.3 Identification
Define the data that you need to identify your device under the "Identification" parameter group.
A distinction is made between data you can set yourself and values that are preset in the
factory.
The default values are write-protected and cannot be changed. The corresponding allocation
is set out in the following example:
Parameter Adjustable Preset Factory setting
Tag X -
Long tag (TAG) X -
Description X -
Message X -
Installation date X -
Device
Manufacturer - X Siemens
Product name - X SITRANS P420
Article number - X e.g. 7MF0440-1GL01-5AF2-Z
Order option 1/ Order option 2 - X e.g. A01+C11+C12+C14+C20+E00+H01+Y01+Y15+Y21
Serial number - X In accordance with the measuring cell selection/device manufac‐
ture
Final assembly number X -
Hardware version - X In accordance with the measuring cell selection/device manufac‐
ture
Firmware version - X In accordance with the measuring cell selection/device manufac‐
ture
EDD version - X
Parameter assignment
9.3 Parameter assignment over remote operation
SITRANS P320/P420 with 4 to 20 mA/HART
146 Operating Instructions, 11/2019, A5E44852162-AC
To Next Page
Loading...
