Siemens SITRANS P - Enable User PIN; Disable User PIN

The user PIN 2457 is factory preset in the device.
Note
Write protection is automatically enabled 10 minutes after the last button operation.
● Enter the user PIN.
9.2.25.1 Enable user PIN
Requirement
The User PIN is disabled.
Procedure
1. Navigate to the parameter view.
Navigating in the views
(Page 76)
2. Select the parameter "User PIN".
3. Use the
button to confirm.
The message "USER PIN ON" (User PIN enabled) appears for 2 seconds.
Result
The User PIN is activated after about 10 minutes or after a device restart.
9.2.25.2 Disable user PIN
Requirement
The user PIN is enabled.
Procedure
1.
Navigate to the parameter view.
Navigating in the views
(Page 76)
2. Select the parameter "User PIN".
3. Use the
button to confirm.
Parameter assignment
9.2 Parameter assignment over device with display
SITRANS P320/P420 with 4 to 20 mA/HART
Operating Instructions, 11/2019, A5E44852162-AC 139