Siemens SITRANS P - Temperature Units [17]; Lower Scaling Point [18]

Certain units are displayed differently on the display and over remote operation. (Page 107)
Setting range: Display (header line) Display (enumeration) Remote operation
KG/Sec KG/S kg/s
Gr/Sec G/S g/s
Gr/min G/m g/min
Gr/h G/h g/h
KG/min KG/m kg/min
KG/h KG/h kg/h
KG/d KG/d kg/d
t/min t/m t/min
t/h t/h t/h
t/d t/d t/d
lb/Sec lb/S lb/s
lb/min lb/m lb/min
lb/h lb/h lb/h
lb/d lb/d lb/d
ton/min sto/m ton/min
ton/h sto/h ton/h
ton/d sto/d ton/d
ton(UK)/h Lto/h ton (UK)/h
ton(UK)/d Lto/d ton (UK)/d
Factory setting: kg/s
9.2.15 Temperature units [17]
Selects the temperature unit for the "Sensor temperature" and "Electronics temperature"
measurements that are displayed in the measurement view.
Setting range: K
°C
°F
°R
Factory setting: °C
9.2.16 Lower scaling point [18]
Sets the lower range value for the scaling.
Depending on the application of the device, you set the lower scaling point as follows:
Parameter assignment
9.2 Parameter assignment over device with display
SITRANS P320/P420 with 4 to 20 mA/HART
130 Operating Instructions, 11/2019, A5E44852162-AC