Siemens SITRANS P - 7.2 Operating the device with display

7.2 Operating the device with display
7.2.1
Navigating in the views
You navigate in the views with the
Buttons (Page 75) buttons:
Views Buttons
Measurement view
After the initialization, the measurement view is displayed.
1. Select a random measured value with the buttons or .
2. Change to the parameter view with the button.
3. Return to the measurement view with the button.
Parameter view The "EDIT" symbol has been activated permanently.
1. Select a parameter with the buttons or .
2. Change to the edit view with the button .
3. Return to the measurement view with the button.
Edit view The "EDIT" symbol flashes.
1. Change the parameter value with the or button.
2. Save the change with the button .
You are in the parameter view.
3. Return to the measurement view with the button.
If you
do not change any parameters, you return from the edit view to the param‐
eter view with the
button.
7.2.2 Measurement view
The measurement view shows the current measured values as well as status and diagnostic
messages:




① Name and unit of the measured value (alternating)
② Measured value
③ Measured value ID
④ Bar display
Figure 7-2 Example of measurement view
① shows the name of the measured value and the set unit as alternating values.
Measured value IDs ③ start with "P".
Operating
7.2 Operating the device with display
SITRANS P320/P420 with 4 to 20 mA/HART
76 Operating Instructions, 11/2019, A5E44852162-AC