Note
To have the process value for "Level", "Volume", "Mass flow", "Volume flow" or "Customized
characteristic curve" shown as the "Start view", first set the associated characteristic curve
using the "Application" (Page 110) parameter.
9.2.31 Pressure reference [33]
Used to adapt the display of the pressure unit to your application.
Setting range: NONE Not specified
GAUGE Gauge pressure
ABS Absolute pressure
Factory setting: NONE
See also
Pressure units [01] (Page 106)
9.2.32
Identify the device [34]
Enables or disables the device identification via HART.
When device identification is enabled, the device signals its identification data via HART.
With device identification enabled, the device responds to a request with the HART command
"Find device".
Setting range: ON Device identification enabled
OFF Device identification disabled
Factory setting: OFF
9.2.33 Reset [35]
Used to reset the following settings:
Setting range:
Restore ordered configuration CUST
Reset to sensor calibration SENSR
Reset DAC trim to the factory setting DAC
Factory reset FACT
Parameter assignment
9.2 Parameter assignment over device with display
SITRANS P320/P420 with 4 to 20 mA/HART
Operating Instructions, 11/2019, A5E44852162-AC 143
To Next Page
Loading...
