Siemens SITRANS P - Page 79

Parame‐
ter ID
Parameter name on
the display
Meaning
06 SQRT POINT Application point for volume flow and mass flow (VSLN and MSLIN) (Page 119)
07 ZERO POINT Zero point adjustment (Page 119)
08 APPLY LRV Apply lower range value (with pressure applied) (Page 122)
09 APPLY URV Apply upper range value (with pressure applied) (Page 122)
10 FAULT CURR Select fault current (Page 124)
11 LO FAULT CUR Lower fault current (Page 124)
12 UP FAULT CUR Upper fault current (Page 125)
13 SATURAT LOW Lower saturation limit (Page 125)
14 SATURAT HIGH Upper saturation limit (Page 126)
15 SV SELECT SV selection, set secondary variable (Page 127)
16 LEVEL UNITS Level unit (Page 127)
16 VOL UNITS Volume units (Page 127)
16 VFLOW UNITS Volume flow units (Page 127)
16 MFLOW UNITS Mass flow units (Page 127)
17 TEMP UNITS Temperature units for sensor and electronics temperature (Page 130)
18 LOWER SCALNG Lower scaling point (Page 130)
19 UPPER SCALNG Upper scaling point (Page 132)
20 LOW FLOW CUT Low flow cut-off for volume flow and mass flow (VSOFF and MSOFF) (Page 132)
21 VESSEL DIM A Vessel dimension A (Page 133)
22 VESSEL DIM L Vessel dimension L (Page 134)
23 BUTTON LOCK Enable and disable button lock (Page 134)
24 CHANGE PIN Change user PIN (Page 135)
25 RECOVERY ID Display Recovery ID (Page 136)
26 PIN RECOVERY PIN recovery (Page 137)
27 USER PIN Enable and disable user PIN (Page 138)
28 DEVICE MODE Active device mode (Page 140)
29 FUNCT SAFETY Enable and disable Functional Safety (Page 140)
30 DISPLAY TEST Display test (Page 141)
31 LOOP TEST Loop test (Page 141)
32 START VIEW Start view (Page 142)
33 PRESSURE REF Pressure reference (Page 143)
34 IDENTIFY Identify the device (Page 143)
35 RESET Reset (Page 143)
36 OVERLD BEHAV Overload behavior (Page 145)
1) The "Application" parameter is also called the "Transfer function" in certain configuration
tools.
Hereinafter,
the
parameter ID is always written inside parentheses after the parameter name.
Example: Parameter "Damping value" [04].
See also
Parameter assignment over device with display (Page 106)
Operating
7.2 Operating the device with display
SITRANS P320/P420 with 4 to 20 mA/HART
Operating Instructions, 11/2019, A5E44852162-AC 79