Simplex 4100+ Service Instructions

NOTE:
The following jumpers are zero-ohm resistors.
JWl = Always IN.
JW2 and JW3 = Factory set. DO NOT CHANGE.
Connectors
Pl = Fits into Socket J2 on the motherboard.
P2 = 26-pin connector for a 166-228 (34”) or a 166-229 (56”) harness. Harness connects to Pl of the first LED
Switch module the card controls.
LED1
SW1
Cl
JWl
P2
tc, I
u “‘1
,
LEO/SUITCH CONTROLLER
ASSY 562-729 E
JW2 81 JW3
1
I
I
Pl
Figure 20
64/64 LED/Switch Controller Board
REMOTE ANNUNCIATOR INTERFACE (RAI) CARD (562-793)
NOTE: This board, also referred to as an External Serial Interface Communications Board, cannot be used for Style
7 installations.
Features and Functions
Passes information to and from the Master Controller and remote serial devices (SCUs, RCUs, remote LED/Switch
Controllers, etc.) either directly or via a Remote Serial Interface (RIC) Card.
Communicates with the Master Controller via Motherboard Connector Pl ; communicates with the remote devices
via contractor wiring.
35
firealarmresources.com

Simplex 4100+ Specifications

General

Type	Addressable Fire Alarm Control Panel
SLC Loops	Up to 10
Operating Temperature	32°F to 120°F (0°C to 49°C)
Humidity Range	10% to 93% non-condensing
Display	LCD
Communication	Ethernet
Power Supply	120/240 VAC, 50/60 Hz
Battery Backup	24 VDC
NAC Outputs	Expandable
Releasing Capability	Yes, with releasing modules
Max Notification Appliance Circuits (NACs)	Varies by modules
Max Releasing Circuits	10
Communication Ports	Ethernet
Max Devices	3, 000