'OTOALARMDISTANCEANDINSERTVALUE
#ONFIRMDATAENTRY
$ATUM - is preset to WGS84 (World Geodetic System
1984), but can be changed to any of the 118 datums
listed in Appendix B e.g. to match old paper charts or
trackplotter data from RS2500/RS4000 (datum #002
European 1950).
The position in the position display and NMEA output
will refer to the selected datum. To select a new datum:
Press [ENT] from the "Navigation setup" display, leaf
through the datum list with +/-, or key in the number,
and confirm by [ENT].
F The datum in the chart display is fixed i.e. WGS84.
$ELTAPOSITION - some paper charts do not indicate a da-
tum, but instead they have a notation to an offset or
delta position to WGS84.
#OURSEANDBEARING - readings of course and bearing
can be made in either magnetic or true.
.AVIGATIONMODE - rhumbline navigation is used for
shorter distances, and great circle for long trips, espe-
cially when crossing high latitudes.
!UTOWAYPOINTSHIFT - in Auto waypoint shift mode the
navigator will automatically change to the next way-
point after passing a waypoint line border, or after pass-
ing a waypoint circle border i.e. if Auto waypoint shift
mode is set to shift at the circle alarm border, then the
alarm function at the waypoint’s line and circle will be
OFF.
0-9
ENT
#HAPTER #%-+))3ETUP
78
To Next Page
Loading...
Need help?
General
