Chapter 8-8 CE33 Miscellaneous menu
The info window below will inform you of the progress of the recep-
tion of data by keeping an eye on the counter. When the counter
stops, means that all the data from the PC planner has been col-
lected. However, some PC programs may continue to transmit the
same data over and over again and will have to be stopped by press-
ing [ENT].
Receive WPs and routes
Reception in progress
37 WPs received
5 routes received
Stop and save
ENT
ENT
Stop and save
- will stop collecting data (if not already finished) and start saving
the collected data.
Waypoints/routes transmitted to the CE33 are added to the WP/route
list. However, if two waypoint/route names are identical, the latest
transferred one will not be saved, even though position(s) may be
different. Routepoints will not be included in the WP list.
Saving the collected data can take anywhere from less than a second
and up to a few minutes, depending on the amount of data. If it takes
too long and you need the CE33 in a hurry, then press the [MENU]
key to Stop saving any more data - what has been saved until this
point will stay in the memory, the rest will be lost.
MENU
Stop saving
Under normal circumstances we assume the saving procedure is
allowed to finish and will indicate “Saving completed” in the info
window. You are now ready to:
MENU
Exit function and return to normal NMEA communication
NB! PC-based planning systems differ in operation and performance
beyond the control of Simrad.
To Next Page
Loading...
Need help?
General
