Simrad CS66
100 20221859 / F
Changing route operation parameters
Route operation parameters may be modified when a route is
active by tapping the Navigation menu followed by the Route
Operation Settings command.
The following parameters may be changed:
Operator signal:
Wheel over warning:
Specifies the time in minutes before reaching the wheel over
point at which a wheel over warning will be given.
Wheel over:
Specifies the warning time in seconds before reaching a wheel
over point. This time has to be min.15 seconds less than the time
defined for Wheel over warning.
Alarm Limit
Sets the off course limit before an alarm is activated.
Leg Display Properties
Toggles on/off the display of leg heading and speed.
ETA calculation
Speed type used for calculating estimated time of arrival.
To Next Page
Loading...
Need help?
General
