SETTING UP THE DISPLAY
20221859 / F 55
Vectors and trail setup
The vectors and trail layout are defined in the Own Ship’s
Vectors and Trail dialog.
Vectors
Show Velocity Vector:
Displays a vector for the course/speed
over ground based on measurement from
the active navigator. The length of the line
is determined by the settings in the
Minutes field.
Minutes:
Determines the length of the vector and
the position of the Stabilisation Indicator.
Show Time Increments
: Shows time increment marks
along the vector.
Show Stabilization Indicator: Indicates the vessel
position in a number of minutes set in the
Minutes field.
Show Heading Line: Toggles on the gyro vector. This
vector is displayed from the vessel bow to
the edge of the screen, and is drawn with
dotted line.
Primary source /Secondary source
Trail: Toggles on/off trail based on
information from primary/secondary
source. The distance between each
trail point is determined by the
settings in the time field.
Reset trail: Restarts the trailing function from the
vessel’s current position.
Time Increments: Toggles on/off time increments.
Time Labels: Adds a time labels. The distance
between each time label is defined by
the settings in the Interval field.
Interval: Sets the interval between each time
labeled trail point.
Note If Secondary source is not activated as described in page 38,
Secondary source tab will be disabled.
To Next Page
Loading...
Need help?
General
