Simrad CS66 - Page 90

Simrad CS66
82 20221859 / F
− The dialog will be closed and the system is ready for
entering waypoints.
Creating a route by using the cursor
For route symbols, refer page 78.
Before the cursor may be used for entering waypoints, the chart
center has to be set according to the position for the first
waypoint. Refer Selecting the chart scale, page 51 onwards.
Use the following procedure for entering waypoints:
1 Move the cursor to the position of the first waypoint, and
press the left cursor key.
− The waypoint with waypoint number and route name will
be positioned on the chart.
2 Continue entering new waypoints by moving the cursor to
new positions and pressing the left cursor key.
3 Insert an additional waypoint between two waypoints by
moving the cursor along a leg and pressing the left cursor
key.
− A movable waypoint symbol will be displayed at the
cursor position.
4 Move the cursor to selected position and press the left
cursor key to fix the new waypoint.
5 Change the waypoint radius by moving the cursor to a
waypoint, and then pressing and holding the Ctrl keyboard
key while using the scrolling function on the TrackMan
Wheel.
− Note that the radius is not validated by the system!
6 Save the route by tapping the Route menu followed by the
Save command.
If it should be necessary to move the chart while using the cursor
for planning a route, this can be done by moving the cursor to
the point for the new chart center and pressing the middle cursor
key.