Simrad GC80/85 Double System Controller
14
988-12721-001
2.4 Bearing repeaters
The Double controller unit outputs step and serial signals used for
repeaters. Even when the emergency power supply is used, the connected
repeaters will be powered by the repeater backup function included in the
Double controller unit.
The following serial signals may be selected:
Low speed (GC80): IEC61162-1 ed.4 (4800 and 38400 baud possible)
High speed (GC85): IEC61162-2 ed.1 (38400 baud possible)
Note! A proprietary Tokimec serial signal may also be available, but this is normally
not used.
These signals may be set separately for each circuit.
For connection of repeaters, refer to the wiring diagrams from page 40
onwards.
To Next Page
Loading...
