Simrad GC80/85 Double System Controller
4
988-12721-001
1 PREFACE
1.1 Compliance statement
Navico declare under our sole responsibility that the GC80/85 conform
with the requirements of:
• The European Council Directive 2014/90/EU on Marine Equipment
modified by Commission Implementing Regulation (EU)
2019/1397 - Wheelmark.
All compliance documents are available in the product’s section at the
following website: www.navico.com/commercial
.
1.2 Disclaimer
As Navico is continuously improving this product, we retain the right to
make changes to the product at any time which may not be reflected in
this version of the manual.
Please contact your nearest distributor if you require any further
assistance.
It is the owner’s sole responsibility to install and use the equipment in a
manner that will not cause accidents, personal injury or property damage.
The user of this product is solely responsible for observing maritime safety
practices.
NAVICO HOLDING AS AND ITS SUBSIDIARIES, BRANCHES AND AFFILIATES
DISCLAIM ALL LIABILITY FOR ANY USE OF THIS PRODUCT IN A WAY THAT
MAY CAUSE ACCIDENTS, DAMAGE OR THAT MAY VIOLATE THE LAW.
This manual represents the product as at the time of printing. Navico
Holding AS and its subsidiaries, branches and affiliates reserve the right to
make changes to specifications without notice.
Governing language
This statement, any instruction manuals, user guides and other information
relating to the
product (Documentation) may be translated to, or has been
translated from, another
language (Translation). In the event of any conflict
between any Translation of the
Documentation, the English language
version of the Documentation will be the official
version of the
Documentation.
1.3 Copyright
Copyright © 2021 Navico Holding AS.
1.4 Trademarks
Navico® is a registered trademark of Navico Holding AS.
Simrad
® is used by license from Kongsberg.
To Next Page
Loading...
Need help?
General
