Simrad GC80 - Output Specifications

Simrad GC80/85 Double System Controller
988-12721-001
37
7.3 Output specifications
Serial output signal
Circuits: .................................................................................................... 18
Electrical: ................................................................................ RS422/485
Baud rate: 4800 / 38400 bps
Data bits: ........................................................................................... 8 bits
Parity: .................................................................................................. None
Stop bits:.................................................................................................... 1
Transmit freq.: ..................................................................... 5, 10, 50 Hz
Output format:
Data no.1
$--HEHDT,xxx.x,T*hh<CR><LF>
Data no.2
$--HETHS,xxx.x,a*hh<CR><LF>
Data no.3
$--HEROT,-xxx.x,a*hh<CR><LF>
Data no.4
$HEHCR,x.x,a,a,x.x*hh<CR><LF>
Data no.5
$HENSR,a,A,,,,,,,,,,,*hh<CR><LF>
Data no.6
$--PTKM,HEALM,xxxx,x,xx*hh<CR><LF>
INS (BAMS)
Circuits: ....................................................................................................................... 1
Electrical: .................................................................. RS422/NMEA0183
Baud rate: ................................................................... 4800 / 38400 bps
Data bits: ........................................................................................... 8 bits
Parity: .................................................................................................. None
Stop bits:.................................................................................................... 1
Transmit freq.:
Data no.1: ...................................................................................... 30 s
Data no.2, 3: .................................................... INDETERMINATELY
Data no.4: ...................................................................................... 10 s
Output format:
Data no.1
$--HEALC,x,x,x,x.x,aaa,x.x,x.x,x.x… …*hh<CR><LF>
Data no.2
$--HEALF,x,x,x,xxxxxx.xx,a,a,a,aaa,x.x,x.x,
x.x,a---a*hh<CR><LF>
Data no.3
$--HEARC,xxxxxx,aaa,x.x,x.x,a*hh<CR><LF>
Data no.4
$--ALR,xxxxxx.xx,xxx,a,a,a---a*hh<CR><LF>