Simrad GC80 User Manual

Simrad GC80/85 Double System Controller
988-12721-001
21
Display test
Press and hold the △/NO.2 key and the ▽/EXT key simultaneously. Check
the display, the key backlight, and the buzzer sound.
The system operates normally if:
1 Display: Shows the image below.
2 Lighting of the display and the keys:
- Lights up at maximum brightness.
3 Buzzer: continuous sound.
4.5 Alarm messages
Central alarm panel
On some installations, it is required to connect the gyro to an external
bridge alarm panel. In these types of installations, the functions mentioned
above and the alarm contact output are used to fulfil this requirement.
BAMS
It is possible to connect to a BAM system via serial connection. Refer to
“TECHNICAL SPECIFICATIONS” on page 34, and “DRAWINGS” on page 40.
Display during test

Simrad GC80 Specifications

General

Type	Gyro Compass
Power Supply	24 V DC
Operating Temperature	-15°C to +55°C
Heading Resolution	0.01°
Heading Repeatability	±0.1°
IP Rating	IP66
Storage Temperature	+70°C
Interfaces	NMEA 0183
Humidity	95% non-condensing