Simrad NX40 - Page 32

Simrad NX40/45 Installation and Operation Manual32
To enter the legs of the route:
> > > Repeat as necessary. To Save: >
7-2-2 Menu options while creating a route:
To add a waypoint to the route
> Add
To break one route leg into two:
Move the cursor to the leg you want to break >
>
Insert > Move the cursor to the new waypoint >
To move a waypoint in the route
Move the cursor to the waypoint >
> Move >
relocate the cursor >
To remove a waypoint from the route
Move the cursor to the waypoint >
> Remove
The waypoint is removed from the route, but the waypoint
is not deleted.
To start navigating the route
> Start
To end creating the route
> End
To delete the route
> Delete > Yes
Tip: The distance and bearing calculator can also be
used to enter a course and save it as a route.