EasyManuals Logo
Home>Simrad>Marine Equipment>NX40

Simrad NX40 User Manual

Simrad NX40
116 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #86 background imageLoading...
Page #86 background image
Simrad NX40/45 Installation and Operation Manual86
Select Antenna height then enter
the height of the antenna above sea
level.
18-5 Setup > GPS
> GPS
GPS Source SimNet: Use the GPS source via
SimNet (GPS port)
NMEA: Use the external NMEA 0183
GPS antenna (Fuel/Nav port).
Static
Navigation When the boat stops or moves very
slowly, the calculated GPS speed
and course become erratic. Static
navigation allows the erratic values to
be filtered:
0.01 to 9.99: If the boat speed
is slower than this, the speed is
shown as zero and the course stays
unchanged.
0 (Off): The calculated speed and
course are always used.
Speed and
Course Filter Waves and wind cause the boat
speed and course to fluctuate
slightly. To give stable readings, the
unit calculates these values by taking
several measurements and averaging
them.
A lower value averages
measurements over a shorter period
of time. This gives the most accurate
value but has the most fluctuations.
18-6 Setup > Fuel
> Fuel
Note: Fuel functions require fuel flow sensors to
be installed.
Source Select the fuel flow sensors to use
if the boat has more than one set of
fuel sensors. Normally select Auto.
Num engines Set the number of engines, or select
0 to disable the fuel functions. If
there are two engines they are called
port and starboard.
Num tanks Set the number of fuel tanks. If there
are two tanks they are called port
and starboard.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Simrad NX40 and is the answer not in the manual?

Simrad NX40 Specifications

General IconGeneral
BrandSimrad
ModelNX40
CategoryMarine Equipment
LanguageEnglish

Related product manuals