Simrad NX40 User Manual

Simrad NX40/45 Installation and Operation Manual90
18-9 Setup > Logs
> Logs
Reset trip dist This resets the trip distance to zero.
Reset total dist This option resets the total distance
to zero.
Reset engine hours Use this option to reset
the engine hours to zero. This can
be useful after an engine service or
to count the engine hours between
service intervals.
18-10 Setup > Alarms
> Alarms
For all alarms select to turn the alarm on or select
to turn the alarm off. For most alarms there is a trigger
value. The alarm will sound each time the alarm value
equals the trigger value.
For example, the
Danger alarm will sound if the boat
comes closer to a danger waypoint than the trigger value
and the Anchor alarm will sound if the boat moves by
more than the trigger value.
You can display the alarm status in the data header. The
alarm status shows the symbol for each alarm that is on.
The symbol is normally black and turns red if the alarm
triggers.
18-11 Setup > Units
> Units
Distance nm (nautical miles), mi (miles) or km
(kilometers)
Distance small ft (feet) or m (metres)
Speed kn (knots), mph (miles per hour) or
kph (kilometers per hour)
Depth ft (feet), m (metres) or fa (fathoms)
Height ft (feet) or m (metres)
Fuel Litres, USGal (US gallons) or ImpGal
(Imperial Gallons)
Compass °T (True north) or °M (Magnetic
north)
Temperature °F (Fahrenheit) or °C (Celsius)
Wind (optional) Requires a wind instrument: True or
App (Apparent)
Transducer; depths
measured below
here
D e p t h s
measured
b e l o w
here
D e p t h s
m e a s u r e d
below here
A
B
C

Simrad NX40 Specifications

General

Brand	Simrad
Model	NX40
Category	Marine Equipment
Language	English