User card window16
A user card is an optional plug-in card that can store
data les. There are three types of les: waypoints,
routes or a track.
To go to the user card window
> More > User card
The user card window has:
File list
A list of the les on any user card in the unit.
To scroll up or down a page at a time
Waypoints, Routes
The number of waypoints and routes currently in the
unit.
Track 1 to Track 10
The number of points in tracks 1 to 10 currently in the
unit.
Note:
To save data onto the user card, use the Save •
command (see below).
Data stored on the user card and shown on the le •
list is not available to be used by the unit until loaded
into the unit with the LOAD command (see below).
Saving data to the user card
> Save > Waypts or Routes or Tracks
This saves all the unit’s waypoints, all the unit’s routes or
one of the unit’s tracks to one le on the user card. For
Tracks, select the track number to save.
The new le is created. Change the name if required.
The new le appears in the le list.
Loading data from the user card to the unit
This loads one le from the user card to the unit:
A waypoints le: The new waypoints are added to •
any existing waypoints in the unit. If a new waypoint
has the same name as an existing waypoint but has
To Next Page
Loading...
Need help?
General
