different data, the unit displays both waypoints.
Select:
•
Skip: Do not load the new waypoint.
•
Replace: Load the new waypoint and replace the
existing one.
•
Skip all: Do not load any new waypoints which have
the same names as existing waypoints.
•
Rplc all: Load all new waypoints which have
the same names as existing waypoints; the new
waypoints replace the existing waypoints.
A routes le: The new routes are added to any •
existing routes in the unit. If a new route has the
same name as an existing route but has different
data then the unit asks which route to keep.
A track le: The new track will replace the existing •
track in the unit.
To load a file to the unit
Select the le to load >
> Load
Deleting a file from the user card
Select the le to delete >
> Delete > Yes
Rereading the file information
> Card > Read
This reads the le names from the user card and displays
them. Reading does not load any le data into the unit.
You should not need to do this.
Formatting the user card
> Card > Format > Yes
Formatting prepares a user card for use. Format the card
if there is an error message saying that the card is not
formatted. Any data les on the card are deleted.
Sorting the file names
> Sort > Sort by > Name or Type or Time
To Next Page
Loading...
Need help?
General
