Simrad TV80 - Modifying the Parameters of a Sensor

122
406388/B
Procedure
1OpentheSetupmenu.
2OntheSetupmenu,selectInstallation.
ObservethattheInstallationdialogboxopens.
3AtthebottomoftheSensorlistpage,selectAddNewSensor.
TheAddNewSensordialogboxopens.
4SelectY es.
5InthePXSensorConguratordialogbox,selectcommunicationportandsensortype,
thenselectConnect.
ThePXMultiSensormk2Conguratordialogboxopens.
6SelectUnlockmeasurements.
TheUnlockmeasurementsdialogboxopens.
7Sendthesensor’sPCBserialnumbertoyourlocaldealer.
Yourlocaldealerwillsendyoualicensekeystring.
8EnterthelicensekeyandselectEnter.
9SelectClosetoclosethedialogbox.
Result
ThePXMultiSensormk2Conguratordialogboxshowsasmany”unlocked”measurements
asyourlicenseallowed,withamaximumofthree.
Relatedtopics
Measurementsdialogbox,page257
Modifyingtheparametersofasensor
WhenyouselectModifySensoryoucanchangeitslocationonthegear,itsname,its
communicationchanneloritsmaincongurationparameters.
Prerequisites
Ifasensorwasaddedtothesystemwith
theprogrammingcable,youwillonlybeableto
modifyitsparameterswhenconnectedtothecable.Ifasensorwasaddedtothesystem
without
theprogrammingcable,youwillbeabletomodifyitsparametersevenifitis
notconnectedtothecable.
SimradTV80ReferenceManual