Sindoh M612 - Page 168

162
501
Modem SPI Write
Failure
Fail to write SPI
1. Check the connection of the harness.
2. Check the Fax card status.
502
Modem SPI Multi
Write Failure
Fail to multi-write SP
1. Check the connection of the harness.
2. Check the Fax card status.
503
Modem SPI Open
Failure (1)
Fail to open SPI
1. Check the connection of the harness.
2. Check the Fax card status.
504
Modem SPI Open
Failure (2)
Fail to open SPI
1. Check the connection of the harness.
2. Check the Fax card status.
505
Modem SPI Init
Failure
Fail to initialize SPI
1. Check the connection of the harness.
2. Check the Fax card status.
506
Fax Total Page
Setting Error
When transmitting Fax, there is invalid management on
the total page.
1. Reset the power
507
Fax Retry Setting
Error
After a transmission fails, there is invalid management on
the number of re-dial.
1. Reset the power
508
Invalid Fax Type
Fax transmission settings are invalid.
1. Reset the power.
509
Fax Print Result
Error
The number of page actually printed does not match to
the value from the callback.
1. Reset the power.
510
Fax Modem Init
Error
The problem occurs when initializing the modem
1. Check the connection of the harness.
2. Check the Fax card status.
511
DMB To Modem
Error
A delivery error of the transmission data to the modem
buffer.
1. Reset the power
512
JBIG Decode Error
(1)
JBIG Decoding error
1. Reset the power
513
JBIG Decode Error
(2)
JBIG Decoding error
1. Reset the power
514
Transmit T4 Image
Data Error
A delivery error of the images compressed in T4
1. Reset the power
515
CDB Error (1)
CDB buffer error
1. Reset the power
516
CDB Error (2)
CDB buffer error
1. Reset the power
517
CDB Write Failure
(1)
Fail to write in CDB buffer
1. Reset the power
518
CDB Write Failure
(2)
Fail to write in CDB buffer
1. Reset the power
519
CDB Read Failure
Fail to read in CDB buffer
1. Reset the power
520
Send Image
Rescaling Failure (1)
Fail to set the width in the rescaling step for the images to
send
1. Reset the power
521
Send Image
Rescaling Failure (2)
Fail to rescale the images to send
1. Reset the power