Sindoh M612 - Page 187

181
In the menu select Printe Skew Page(B-Se)(duplex) to print on Letter or A4 paper.
 Print Skew Page
Make sure of the changes by printing Skew Test Page after changing the margin or the
scales. If yu have change the settings, select this menu to make sure of the results from the
changes.
 A4-LT Margin Gap
1. Set up the left side margin for A4 double side page. Enter additonal margin to the
Letter double side page.
2. The print margin ranges are as the following and it can be changed by 1
unit(=0.2mm).
Class.
Value
Top Margin
-25 ~ +25
Left Margin
-25 ~ +25
 Beam Adjust
This is a menu to change LSU Beam Power (light amount). The image gets darker by
increasing the value to the default +75, and lighter by decreasing the value.
 Quality Pages(Print quality page)
To print Quality Pages,
M611/M616
M612/M617
1. Select Printer service in the diagnostic
mode.
2. Select Hardware test
3. Select Quality Pages to start to print
4. Press [Back] to exit.
1. Select Printer service in the diagnostic
mode.
2. Press Next button at the lowr right side to
move to the next page.
3. Select Quality Pages to start to print
4. Press EXIT to exit.
While printing the pages, any additional operation on the button will be overriden.
The first page is for checking Skew and the next page is for confirming the print Quality
Page.