183
The following sensors and switches are available in the sensor test mode.
- Input Sensor
- Exit Sensor
- MPT Empty Sensor
To do sensor test
1. Select Printer service in the diagnostic
mode.
2. Select Hardware test
3. Select Sensor test.
4. Press [Back] to exit.
1. Select Printer service in the diagnostic
mode.
2. Press Next button at the lowr right side to
move to the next page.
3. Select Hardware test-Sensor test
4. Press EXIT to exit.
In case any of 3 sensors mentioned above or the status of any switch has been changed,
when entered into the sensor test mode, it is displayed on the LCD.
While entered into the sensor test mode, for an example, the cover switch works normal if
you press MPT Empty Sensor or release it and then the message MPT: On / Off is
repeatedly and normally displayed. if the display works abnormal, inspect the sensor since
there is a problem with the cover switch.
Solenoid Test
This test can be used to decide whether solenoids installed inside the machine work
properly, or not.
The following solenoids are available in the solenoid test mode.
- MPT Pick up Solenoid
- Duplex Solenoid
To do a solenoid test
1. Select Printer service in the diagnostic
mode.
2. Select Hardware test
1. Select Printer service in the diagnostic
mode.
2. Press Next button at the lowr right side to
To Next Page
